cnc logo
Home Products Brochure Ordering Contact Us About Us


Edge Index

When you choose an edge to be applied to your doors, it will automatically be machhined to all of the doors on your order. If there are some doors that do not require an edge detail, you must specify this on your order sheet. You may also request that the edge be put on certain sides of the door as well. In this case also you must also specify this for each door required on your order sheet (eg: edge top & Bottom only, edge 1 height & 2 width, etc.)

G edge profile
G edge
N edge profile
N edge
B edge profile
B edge
C edge profile
C edge
O edge profile
O edge
R edge profile R edge
1/8" R edge profile 1/8" R edge
1/16" R edge profile 1/16" R edge
square saw cut edge profile square saw cut edge
appliance panel profile
The scooped edge is 3/8" deep so on a 5/8" thick panel it will leave a 1/4" thick lip
appliance panel

doors frames
 


All Contents Copyrighted CNC Woodcraft Ltd. 2000-2018. All rights reserved.
Access=http://www.cncwoodcraft.com