cnc logo
Home Products Brochure Ordering Contact Us About Us

Create Your Own Look

By adding your own mouldings to our doors, you can create a style and look that is uniquely yours.  As you can see in the drawings below, there are different ways is which mouldings can be applied to the doors.  Mouldings can be applied to all classic style doors and are not just limited to the examples shown below.

In examples #1 & #2, mouldings are applied to shaker style doors that have a flat recessed panel.  The standard recess depth (A) for these panels in 1/4" and if a different depth is required it must be noted on your order form at the time you place your order.  These doors should also be labeled as doors for moulding (ex. 5000 Shaker for moulding) so that the inside edge of the rail is left square to accept the moulding.  When you specify the rail width remember to allow for the extra needed for any moulding overlays.

In example #3, the flat section (B) at the bottom of the profile is 1" wide.  If a different width is needed to match your moulding please specify the width that is required on your order sheet along with a sketch.

If you are applying moulding to a door as in example #4, specify a wider rail width (C) to accommodate your moulding.

If you have any questions on how to order any doors so that you can apply your own mouldings, please call us at (905) 688-9777 and we will be glad to help you out.

 

own design doors

5000 Shaker for moulding
(Example #1)

5000 Shaker for moulding
(Example #2)

7500 Classic for moulding
(Example #3)

7500 Classic
(Example #4)

 

door sample #1door sample #2

Illustration above shows a customers door with their own moulding applied to a 5000 Series door with a "N" edge as shown in example #1 above.   Illustration above shows a customers door with their own moulding applied to a 7500 classic door, 3" rail with "N" edge as shown in example #4 above.

 

doors

 


All Contents Copyrighted CNC Woodcraft Ltd. 2000-2018. All rights reserved.
Access=http://www.cncwoodcraft.com